TTI dimmers to Elation DMX MULTI/DATAPAK

[baribuneo]

Hi,
I have 4 sets of TTI 2.4Kw dimmer packs. I'm looking to connect them to the Elation MULTI/DATA Pack DMX/Analog converter that we purchased last year. Would you happen to know the wiring scheme from each dimmer pack? Also, I believe there are a total of 8 wires from each pack of six dimmers. I'm assuming that 6 of them are channel specific and one is a ground, but I don't know what the last one is for. The Elation unit has a DB25 female receptacle for the analog output. Would I create a DB25 cable from the dimmer packs wires? What would I do with the "ground" wire as there will be 4 total? What do I do with the unidentified wire from each pack? Thanks for any and all of your help.

[derekleffew]

See this thread: http://www.controlbooth.com/forums/l...ld-dimmer.html and http://www.controlbooth.com/forums/l...r-console.html. It's possible that wire#7 carried voltage to the console, so you should be fine not terminating and insulating it.

I seem to recall some dimmer packs using 8-pin Cinch-Jones and others using 10-pin. In either case, dimmers 1-6 are pins 1-6, with common on the last pin, #8 or 10. Here's a link to the 10-pin: http://www.controlbooth.com/forums/l...html#post97026.

[JD]

Yea, what he said

Both TTI and EDI put power on one of the pins. (25vac, but it's been a few years) They marketed a couple of passive controllers that were powered by the pack. Just ignore that pin. EDI used the 8 pin C/J and TTI used the 10 pin. EDI was 2.6 to 7 volts (black to full) and TTI was 0 to 10. Some of the middle aged EDI was 0 to 10 as well.

When you go to use these older analog packs, you may want to have them tuned up a bit. By now, the low end trim and end ramp adjustments have probably drifted, so you may find brightness differences between channels. Easy to fix, if you can find a shop that will do it as compared to trying to sell you a new system. As these adjustments must be made with the unit apart but powered up, I would not recommend doing it yourself. (Some, I think, did have trim pots that did not require opening the unit.) Good Luck!

[baribuneo]

Thanks for your replies. JD, thankfully they have an adjuster on the front of each dimmer that you can turn with a screw driver. I emailed Steve Short over at Litetrol as well and he sent me a copy of the pin outs for this. I've attached it for anyone else who might need it in the future. Thanks again.