|
|
|
|
||||||
| Notices |
| Lighting For any discussions related to lighting |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 21st, 2008, 03:32 PM
|
|||
|
|||
old 1220 XR scanners
got two of these units They have been working fine (really...<g>) well the DMX cable was cut while running. After repairing the cable (yes data is on pin 2) they will not recieve info from the controller. Data passes through to the other fixtures after these fixutres but 1220 are dead . Is it possible that somehow the DMX card on both units has shorted or something..... love the lights but no parts are being made for them any longer..... Any ideas....
__________________
Lee Lighting tech [email]Lee@spsound.net[/email] "Once you lick the lollipop of mediocrity, You will suck forever" 
|
|
September 21st, 2008, 05:18 PM
|
|||
|
|||
|
Re: old 1220 XR scanners
Several ways to troubleshoot.
1. Get a tester. Test data before the signal gets swapped. 2. Run a line direct from the desk to the fixture, plus a swapper. 3. Get another desk, something even 8 channels is fine, just so you can send a new data signal. Troubleshooting is merely eliminating possibilities. Is it possible the addresses got changed?
__________________
http://www.chicagolightingdesign.com "I don't feel it's healthy to keep your faults bottled up inside me." - Bucky Katt
|
|
| Tags |
| (no prefix), 1220, scanners |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DMX Profile for Roboscan 1220 | Sylak | Lighting | 1 | June 14th, 2007 04:02 PM |
Linear Mode
