 |
|
|
||||||||
| Notices |
| Multimedia and Projection A place to discuss all aspects of video, multimedia, and projection in theatre and other events. |
 |
|
|
LinkBack | Thread Tools | Display Modes |
May 23rd, 2008, 02:50 AM
|
||||
|
||||
Relamping lamp modules
Christie makes a jig for properly aligning Xenon lamps in their housing for some of the newer projectors. Has anyone successfully tried relamping their own lamp modules?
I am actually looking at doing my own relamping for the Barco ELM R18 projectors (cost factor as well as turn around). I have most of the specs from one lamp manufacturer to do this but no one that I have found has an alignment jig for this projector. The risk that I run is not getting the intensity from the module. I did hear of someone doing this and destroying a lamp module when the lamp blew (once out of many relampings). I had this happen once when I had one done by the manufacturer so I am not too worried. 
|
| Sponsored Links |
|
| Tags |
| lamp, modules, relamping |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thorn 600X lamp | Lightingguy32 | Lighting | 12 | January 28th, 2007 10:09 PM |
| FEL and FLK | propmonkey | Lighting | 17 | January 9th, 2007 03:31 AM |
| Short Lamp Life in Tungsten Movers? | gafftaper | Lighting | 13 | December 20th, 2006 01:42 AM |
| AC or DC....that is the question | propmonkey | Lighting | 34 | November 28th, 2006 01:23 PM |
Linear Mode
