|
|
|
|
||||||
| Notices |
| Sound A place to discuss sound reinforcement and design. |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 3rd, 2009, 10:01 AM
|
|||
|
|||
Hanging mic and floor mic
Hi, I have a hanging mic and floor mic on seperate channels on a mackie 1402-vlz pro mixer. the mixer then goes to an amp, and then to my speakers. The problem is I can't get anything out of either mic. I have a few wireless mics on the board as well and they work fine. I have phantom power turned on, checked and replaced all the lines and connections, still nothing. Any thoughts on this would be appreciated, thanks.
|
|
March 3rd, 2009, 10:30 AM
|
|||
|
|||
|
Re: Hanging mic and floor mic
Sigh, nevermind....I had the mics plugged into the 1/4" jacks, not the XLR. Apparently the 1/4"'s don't get phantom power, just XLR. I hate being a newbie.
|
|
March 3rd, 2009, 10:41 AM
|
|||
|
|||
|
Re: Hanging mic and floor mic
Glad we could help
|
|
March 6th, 2009, 01:19 AM
|
||||
|
||||
|
Re: Hanging mic and floor mic
Well, the good thing is that you'll remember that next time and probably never make that mistake again. That's one of the best ways I remember things...by messing them up first.
A couple of hard knocks is alright now and then, right?
__________________
A lack of preparation on your part does not constitute an emergency on my part. Wolf <><
|
|
March 7th, 2009, 08:11 AM
|
||||
|
||||
|
Re: Hanging mic and floor mic
Look at the good side, you figured it out and got it fixed. And you probably learned more than if someone had simply given you the answer.
__________________
Brad Weber audio, audiovisual and acoustical consultant www.museav.com
|
|
| Tags |
| floor, hanging, mic |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
