Ok so the trainer is coming on thursday for the Ginie Lift
we have an AWP25 Gini lift with super straddle and we are about to get trained on its use.
the guy from Gini wants us to have it set up when he comes ( I thought this was part of the training but I guess not.) the set up is intended to straddle the seats then it rolls back and fourth so that we can adjust the lights.
a Ginie AWP25
The problem is this:
Each row of seats going back has a small step between them. only one step per row and about 5 inches high so not huge. We can get the super straddle set up, but to get the Ginie lift itself up the steps and over the arms of the straddle at the same time is proving to be a challenge since the Gini has to remain at the same attitude as the straddle arms. in all the videos and photos I have seen the floor is level or sloped with no steps. How do I get it over the steps! we were thinking of some sort of rail system. for the lift to roll up with the straddle in place. then raise the Ginie off the rails with the super straddle. but I can see possible safety issues there. Run away train!
There is no room to turn it in the area so we cannot set it up on level ground then roll the whole thing into place so it has to be set up in the isle next to the row of seats it will straddle.
anyone else dealt with one of these were steps are involved? or anyone with ideas?