Recent content by Radio

I have tried it in both 6channel and 10channel mode, no difference.

Every other channel of the same fixture. I've tried direct to the fixtures and thru dimmer rack with the same results.

DMX is terminated and Patch is #0, which is 1:1. Battery replaced. All Memories Reset. The problem still persists.

I am running in six channel mode with no intensity master. I will verify DMX terminator tomorrow.

I did try these on channels 19-24 and 25-30 with the same results, so a totally different bank of faders. I know I went through and reset the Memories, but I need to go back and make sure I reset the Patch to #0.

Yes, I am just swapping the DMX cable. I though I had reset the Patch to 1:1, but I will double-check. No Monitor. Memory has not been a general issue, so I doubt it's the battery. I'm afraid Covid caused major restructuring and retraction at Leprecon. I was deeply saddened too. Their...

I'm having a problem with my Leprecon 1624 control console. It controls dimmers with no problems, but when driving my ColorKey WaferPAR HEX 12 Mk2s. When the LEDs addressed to channels 19-24 every other has only a three step dimmer curve 0/30/100%. Readdressing makes no difference. If I...

The Furman unit would replace one of my dimmer packs and be connected to my standard patch bay(spider patch) to six of the former patch points.

Most of the sequencing relay systems I'm finding out there are gross overkill for my theatre's needs. Right now I'm trying to determine if a Furman ASD-120 2.0 will give me what I need in the short term to run a mixed rig. This would give me six 20A channels with sequenced start-up and a...

Unfortunately, the dimmer system I'm working with does not allow me to switch in Relay Modules for Dimmer Modules. That would mean installing different dimmer system to accommodate accepting Relays, which seems much less cost effective. Though it looks like I can use the Test buttons on the...

This may be obvious to some, but I've been working on theatre lights since the '70s and it's not obvious to me. If you upgrade and install a full LED based lighting system in a theatre, I know the instruments want continuous AC power. The common way I've seen this done is to install theatrical...

I used to work for the Spartanburg Little Theatre in Spartanburg SC. I had a 'B' size round simple kited made. It should still be in the gobo file there.

If the Leprecon 612 is a functional board, check its outputs. If it has both Sinch-Jones and DMX outputs, it can drive both at the same time. So you can easily have a dedicated six channels of analog for your conventional dimmers and the other six for your LEDs without going through the...

Recommend you switch to GLC , FLK, or HX601 lamps. HX601 rated for 130v.

For Microphones, check out the Point Source Audio website. Generally good cheaper alternatives to many of the major brands.