These Ads will no longer appear once you have logged into ControlBooth.

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Adding show relay to comms sytem

Discussion in 'Sound, Music, and Intercom' started by JonasA, Dec 14, 2011.

  1. JonasA

    JonasA Member

    Messages:
    57
    Likes Received:
    4
    Location:
    Melbourne, Australia
    I realise that more information is needed to fully answer this, but I'm working on a show this week and really need to work out a solution ASAP.

    I'm using a Jands Ezicom system (older version - master station is an E-200, beltpacks are the E-100 model), and I'd like to put in a show relay feed. Currently we have show relay set up to run to speakers in the dressing rooms, so it's about how I feed this signal into the Ezicom.

    There's no line in/mic in on the master station, so I'm stumped. Anyone have any ideas? I can get the relay feed as balanced/unbalanced/anything thanks to our very helpful sound technician.

    (I'll post more information once I'm back in the theatre tomorrow)
  2. Chris15

    Chris15 CBMod CB Mods Premium Member

    Messages:
    3,733
    Likes Received:
    282
    Location:
    Sydney, Australia
    The simple solution...
    Swap the E200 out for an E400 that does have a PGM input...

    But that not being a readily available option, I guess the easiest option is going to be to attenuate a line level signal down to mic level and stick that into a headset connector's mic lines...

Share This Page