Chauvet 38 parcan

Need help connecting chauvet parcan 38s to a chavuet obey 70 controller please just need the sitting of the 38s for some reason right now they do there own diffrent colors please help I have a wedding in a hour
 
Assuming they are Rev 3's, the manual says you have to set the mode to either 3-channel or 7-channel and assign a DMX address. They probably default to one of the programmed modes. The Obey 70 has to be patched to match. I would suggest 3-channel mode to keep it simple.

DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must
set the starting address for this mode. If this is your first time using DMX, then it is recommended
that you refer to the “DMX Primer” section in the “Appendix” of this manual.
1. Press <MENU> until 3-CH or 7-CH appears on the LED screen.
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired DMX address (d001~d512).
 
Thank you so much. Unfortunately I didn't have service or internet to have done this. But thank you I will be sure to let you know how it turn out
 

Users who are viewing this thread

Back