These Ads will no longer appear once you have logged into ControlBooth.

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Emulation - USB/DMX dongle

Discussion in 'Lighting and Electrics' started by RandallCook, Jan 26, 2012.

  1. RandallCook

    RandallCook New Member

    Messages:
    18
    Likes Received:
    0
    Location:
    Cincinnati, Ohio
    The USB part of my Emulation - USB/DMX dongle got crushed.
    My question is: will any USB/DMX cable/system work with Emulation? Or do I need to buy the cable again for $500?
  2. JD

    JD Well-Known Member

    Messages:
    2,637
    Likes Received:
    423
    Location:
    North Wales PA
    If it is at the chip end, you are probably best to send it to the manufacturer for "repair." They will most likely charge you some "flat" rate, send you a new one, and throw the old one out.
  3. derekleffew

    derekleffew Senior Team Senior Team Premium Member

    Messages:
    4,852
    Likes Received:
    1,988
    Location:
    Las Vegas, NV, USA
    The software will only work with Elation hardware. BUT, perhaps Elation will exchange the dongle for a nominal fee. I'd shoot this guy an email:
  4. RandallCook

    RandallCook New Member

    Messages:
    18
    Likes Received:
    0
    Location:
    Cincinnati, Ohio
    Thank you!
    I'll try service dept.!

Share This Page