Hi all I just wondered if somebody could give me a little assistance about what dip switch settings I need for my new Laser? (I'm quite new at using DMX) I've just recently bought a new RGY laser off E-Bay from a company called "Meierlight" (Part no: ME-LAS IV) & I am also using a standard DMX 512 controller (DMX Master 192). I’m just finding it a little hard getting the controller to work with my laser. If I turn the number 10 dip switch on the laser to on (To turn the laser into DMX mode) & I also turn switches 1 & 3 on, I can control & access some patterns & that’s about it. If I then put switch 10 on again, although put switches 1 & 4 on instead, I can then access different patterns (although not the ones when I had the 1 & 3 switches on), colours, rotations etc, although they’re not in the order on the controller as stated in the manual. I wondered if anybody may of known what the correct dip switch settings should be? The laser has 16 channels & the controller can support up to 192 channels. Your help shall be much appreciated. Thank you for your time & help.