Sayen
Active Member
On an Innovator 600, does anyone know how to access DMX traits not listed when you select a moving device? There are only five or six encoder wheels, and considerably more traits for some devices.
Does anyone know what part of the .ddl file determines which traits show up on encoders? How about the order of commands (does Lamp On really need to be the last command?)? I generally move everything with the trackball, so I really don't need pan and tilt most of the time.
I've called Leviton tech support, but they either don't call back, or I get the fun of teaching the technician how to run the board, which was my last two calls. The manual is very useful, it's holding up one leg of the table the console sits on.
Does anyone know what part of the .ddl file determines which traits show up on encoders? How about the order of commands (does Lamp On really need to be the last command?)? I generally move everything with the trackball, so I really don't need pan and tilt most of the time.
I've called Leviton tech support, but they either don't call back, or I get the fun of teaching the technician how to run the board, which was my last two calls. The manual is very useful, it's holding up one leg of the table the console sits on.