MagicQ and Enttec USB Pro

[Esoteric]

Hey guys. I am using a Dell laptop and an Enttec USB Pro with MagicQ.

I currently have it hooked up to a Studio Command and I don't seem to be getting any DMX out of it. It shows up as a COM port in my devices, but it doesn't seem to do anything.

Mike

 

[Esoteric]

Hahahahaha!! Got it!!

Mike

 

[LightingPenguin]

Glad my advice came in handy. Gee I'm such a wonderful person.

in all seriousness, good job

 

[Footer]

Hahahahaha!! Got it!!

Mike

And the problem was....?

I have never used that software with the Enttec, used it with the SN110's just fine.

 

[Esoteric]

It was stupid. All the universes are set to Artnet. I had to set it to Enttec. Shows what I get for now reading the directions.

Mike

 

[lightman02]

It was stupid. All the universes are set to Artnet. I had to set it to Enttec. Shows what I get for now reading the directions.

Mike

Also you need to use the driver that Chamsys gives you off their website for the Enttec. The standard driver that Enntec provides will not work, however this is stated very well with the installation instructions off the Windows install documents.

 

[Esoteric]

Also you need to use the driver that Chamsys gives you off their website for the Enttec. The standard driver that Enntec provides will not work, however this is stated very well with the installation instructions off the Windows install documents.

Yeah I did that.

Mike

 

[lightman02]

I know, I just wanted to put it in here in case someone has the same issues it will give them some information.