RBG color mixing utility . . . great for LEDs

BillESC

Well-Known Member
Now you can see every color of the rainbow with this slick RBG utility.

proxy.php


You can down load it here:

http://www.vias.org/simulations/bin/colormix_eng.zip
 
Another fun little toy, not quite as cool as that gobo rotator software, but very useful especially as a teaching tool. Thanks!
 
IS THERE SOMETHING LIKE THIS WITH CMY?!???!

questionquestionquestionquestion!!!!

I'm getting a Hog2 for my Talent Show this year, and from what I can tell there is no wonderful touchscreen "I'm going to show you a rainbow of colors and you're going to presss the one you want" option, and I had it on the Maxxyz and I frigging want it again. So I figure if I can't do the actual point and touch on the Hog2, I can at least find some way to get the values via a visual rainbow system, and then just input into the board.

I figure I can do it via MaxxyzPC if need be, but is there a better way--like this program?
 
IS THERE SOMETHING LIKE THIS WITH CMY?!???!
questionquestionquestionquestion!!!!
I'm getting a Hog2 for my Talent Show this year, and from what I can tell there is no wonderful touchscreen "I'm going to show you a rainbow of colors and you're going to presss the one you want" option, and I had it on the Maxxyz and I frigging want it again. So I figure if I can't do the actual point and touch on the Hog2, I can at least find some way to get the values via a visual rainbow system, and then just input into the board.
I figure I can do it via MaxxyzPC if need be, but is there a better way--like this program?

See if they will rent you an iPC. Hog3 has the color picker, and usually you can get an iPC for cheaper then a Hog2.
 
DarSax said:
IS THERE SOMETHING LIKE THIS WITH CMY?!???!
I thought about adding CMY sliders to the gobo visualizer. Its already programmed, but I scrapped it at the last minute because the values were way off from the MAC 700 I tested on. The sliders would tell you what the CMY value is for a gel, but again it was way off. The best way I could convert CMY values to RGB was based solely on the percentage of the slider. Which gave mixed results because the HEX values were only numbers.

Matt McCormick
www.cablepick.com
 
Last edited:

Users who are viewing this thread

Back