5K Fresnel on 2.4 k dimmers

pudgeo2

Member
So, I'm ME on this show, and the LD wants to use a 5k Fresnel, the only problem is I only have 2.4k dimmers. I don't really have the budget to rent 5k dimmers. I thought that I once heard that you can combine dimmers. Has anyone else ever heard of this, and if so how do I do this? P.S. I know that 2.4 + 2.4 is only 4.8, and that still isn't enough.
 
No, you cannot combine dimmers to accept a single load larger than 20A.

You have two solutions:
1) Rent a single 6Kw dimmer
or
2) Use a maximum 2Kw Fresnel.
 
Dimmers work by chopping the waveform, but no two dimmers are going to be aligned that closely. One will always be getting hit first as they cut in. That's only the first reason not to! Small resistances in things like plugs and part tolerances will also lop-side the load, and heaven forbid you end up trying to parallel two dimmers on different phase legs! About the only time you can get more than 2.4k on a 20 amp dimmer is if the dimmer is designed to run on 220v, and you are operating a 220 volt lamp. (Not too common over here in the states.)

One other note, the current curve on a lamp is not liner to the voltage curve, so a 5k lamp will already be drawing over 20 amps at 25%. (That is if the breaker holds past the preheat inrush!)
 
As was said, you have two choices: get 2k fresnels, or rent a 5k dimmer.

Its not only the dimmer that your issue is, you also need rated cable to get from the dimmer to the fixture. Most theatrical cable is only rated for 25A, you'd be looking to pull around 41A through it.

As was said, you can't use two dimmers for one fixture, and because of the way SCRs work, you can't just keep the fixture dim. (and even if you could, that defeats the point of using a 5k fresnel in the first place).

Tell your designer to find the money to rent a dimmer and cable, or to come up with another solution to the problem.
 
...Tell your designer to find the money to rent a dimmer and cable, or to come up with another solution to the problem.
How about a 2K lamp in a 5K fixture? Provided LCL is the same of course. Would still need a 20A-60A adapter.
 
Last edited:
How about a 2K lamp in a 5K fixture? Provided LCL is the same of course. Would still need a 20A-60A adapter.
Well, assuming that sine the OP does not have 6K dimmers he probably doesn't own 5k fresnels. So, no reason to change lamps and use adapters when you could just rent 2K units.
 
Last edited by a moderator:

Users who are viewing this thread

Back