lcthebeast
Member
I have a 300' run of dmx I run through our ceiling to the middle of the house for programming for shows time to time. Recently it somehow received a nice tear down through the shielding and cut open one of the data lines but it wasn't severed. What's the best way to repair this? I have someone on staff who can solder well.
The dmx can still control the dimmers, but is ghosting a few of my older dimmers. I have 2 etc unison racks with 12 d20 units in each which are fine, and 21 7.2k dimmers from our old pig tail patch which are ghosting a select few.(for extra useless info)
I was thinking cutting it before the tear and just putting the connector there... or cutting it and splicing it
The dmx can still control the dimmers, but is ghosting a few of my older dimmers. I have 2 etc unison racks with 12 d20 units in each which are fine, and 21 7.2k dimmers from our old pig tail patch which are ghosting a select few.(for extra useless info)
I was thinking cutting it before the tear and just putting the connector there... or cutting it and splicing it