Recent content by ahat30

no let me back up, I have a Chauvet DMX Splitter and there is a DMX male to cat5 cable coming out of that splitter into a separate switch. i did make it sound like it was a chauvet switch but that wasn't my intention, i apologize. the DMX/Cat5 turnarounds were either made by the installers or...

No schematics provided to us to see if they are the first or last, however I do believe the "working" ones are the first in line and then we get to all the non working ones. They are not random in the string. I don't know if that string is terminated due to it being mounted on the ceiling...

really haven't thought about a bad fixture...DMX cable I have thought of but no way of testing that theory out since they are high up.

Hi folks, any help would be great on this. I have a chain of 12 Chauvet SlimPar Tri 12's and only 5 of them are responding. We transmit using art net, and use Byron for software. Here is what I have tried so far: Deleting and repatching fixtures to same address Revert Byron to earlier...

Ok guys, an update. I'm still having this issue but here is what I have learned. I took my laptop, with an M1 board down to the stage where the DMX in the floor pocket it. I opened our show file in Byron, and was able to control all LED's on this Universe that is giving me the trouble and now...

We'll, I'm back. Came in this morning and the LED's were back at it, but not as bad. I played with disconnecting universes and reconnecting at the board, and finally have them stable. I have no clue as to what it may be now since its happened while hooked in to the smaller console. Thoughts?

Ok, finally got the M1 board to be recognized by Byron, firmware update, and I have no more issues with the lights as stated above. My conclusion would be the board is bad. Thanks everyone for helping me out.

anyone ever have an Jands S1 board go bad? I have tried several different things as well as the terminators. I have done a home run shot from the floor pocket to an individual light and it still does blinks, flashes, etc.., even with a terminator on it, tried to look for a DMX speed setting on...

I use a Jands S1 board with Byron software. I'll check to see if that is even an option. Thanks

This is actual DMX rated cable, yes

this morning I found a 3 pin terminator, plugged it into the Loop Through out on the splitter. All of the fixtures stopped going crazy, however every once in a while they would blink. So I think I am on to something with the terminator.

It's a stage ape 3 pin splitter with 4 outputsI am using 3 pin DMX

I just installed all new LED's in our Worship Center, 2 Chauvet QWash 560z's, 2 412 Legends, and 10 Slim Par Tri 12's. I am having a problem with all of them going out of control, flickering all in sync. The only way I can get them to stop is if I unplug the splitter from the single DMX output...

I didn't, but I ran it up and now I have it functioning correctly. I didnt think that had to be up, is this new in Byron?

i had a similar issue one time with our house lights flickering and it was on one row of lights, all just conventional ETC Pars using 750w lamps. The issue turned out to be a bad Power Block in the Dimmer itself. We used the ETC Smartpack and it was found in there. We checked the temperature...