Recent content by anatorian

What we discovered (only after reading the PDS-902 manual and making a guess as to if it applied to the SPII) is that the SPII doesn't support 1:1 pixel sampling when the pixel clock is over 150MHz. Since the iMac worked perfectly it must have a pixel clock under 150MHz by default. On the...

Cross post from creativecow...We are having some problems getting VGA signals to look good passing through our SPII.DVI and SDI inputs work perfectly. We are using a grid to tell if the 1:1 sampling is working (individual pixels in a 1920x1080 grid so you can immediately see if you are not...

Hello,Does anyone know if the composite output on the Barco ImagePRO is always active at 480i/525i resolution? Or does the output of the ImagePRO have to be set to a suitable resolution for composite video?That is can I use the same image pro to send HDSDI to projection and composite to a...

Hello,I have an event coming up where it will be necessary to stack 2 barco projectors to achieve desired brightness. However the lens will be the 0.73 TLD. Is it going to be possible or very difficult to align these units with such a short throw?

I have a barco clm r10+ running along either side of a panasonic 3 chip screen.I am looking for a way to increase the color saturation of the barco to get closer to the panasonic. Obviously a single chip can never match the 3 chip, but I would like to get the color as close as possible.With...

Hello,I'm a bit new to large rental and staging projectors, but we recently received a pair of Barco CLM R10+ units. Both have about 3000 total hours and one has lamp hours in the low 70s, while the other is in the mid 600s. As soon as we received the units we sent them over to a qualified...

Hello All,I am using a Barco ImagePRO 3G connected SDI (1080i) to a Panasonic DLP. For some reason the left side of the image seems to loose just a couple of pixels, and it appears these are wrapped around onto the right side. I've reset the ImagePRO and looked for some sort of fine sync...