Recent content by Atticus159

Okay. The dimmer in question B lights up but has no response to the board. Dimmer A is working fine. These dimmers have channel breakers built into them so they can be reset, no conventional fuses. I have NOT blown one that I"m aware of.

I wonder. I had used another dimmer pack originally and it did this and so I switched it out with the pack I"m currently using with the same results.

Thanks man. I'll look at it. when I ordered these dimmers from leviton the supplied the 3 pin cables for it. I never considered they'd be wrong for the system.

Okay. I switched the addresses and now the first pack now 5-8 is still working fine. The second pack now 1-4 has full LED but is not responsive. Perhaps it is the cable. I've never had a problem with this on my setup at school, but this is pretty strange. When I connect each pack individually...

Thanks Dave, I'm new at this.

Four 300 watt pars. Everything is currently on one circuit. I will move the second dimmer and see if that has an effect. Thanks for your help.

The LED on the second pack stays half lit on all four channels, but it's unresponsive.

Okay. At first glance it worked great and then the second dimmer just stopped responding. Could the dimmer pack be bad?

I'm using a imagenation mc1224cm that I've had for a long time. It's been very reliable and works on my school system very well. I am doing this small piece as a remote with two packs and it's killing me. I'll try your suggestion. Thanks.

Hey guys I"m using a Leviton D4DMX dimmer and control board for a small theatrical production. I am daisy chaining the dimmer packs, two of them together, but the second pack, with a separate address of 5-8, does not respond to my board. Am I leaving some vital step out here?I am using 3...