Recent content by Ben Robertson

i see this is super old, and that you have found solution. With MPC software the fixture profile software shows standard library and user library. when you export the new profile, it should show up in the selection of fixtures

likely your approach would work for the double lens as the rim for these is much larger than the single lens

i have spoken to a fitter and turner frioend and come up with some ideas, i will post pic to see if there is room for improvement.The basic idea is to 3d print a base plate which can be secured to a drill press table.It wil have a slightly raised circle which fits in side the bottom of the...

Hi all, i hope this finds you well.Im looking for advice from some industry vetrans that may be able to help me on the best method to re-secure lenses where the existing adhesives have failed over time .I picked up 30 robo scan fixtures for $11.50 each which while old still use propper...

Any advise on jig design on methodology to get this lens fit correctly would be greatly appreciated, also any recommendation of other forums that may be able to shed some insight great.

lens seated correctly

lens fit - not seated correctly

no lens fit

roboscan lens refurb