Recent content by blademaster

Out of everything I say, not even a welcome back. lol Yes Colin, ladies too. :P

So after a long long hiatus from ControlBooth and the Pro Sound world in general I have been roped back into things.I now find myself speccing out a new kit for a church my family attends.It feels good to be back in the saddle again.So... How's it been going since I've been gone?

That Audix looks sweet but if any one has worked with a church before, budget is a relative and fickle term. the sound budget generally is either from specific donations that people have specified towards Sound or equipment people have donated.I will see about trying the sen in front of him...

he wears the mic around his neck with the mic right next to the flute. i'm worried about the musician bumping into the mic on a stand. we've got a couple sm58 and sens e835 ( i think the model is right). i'll have a look at using it in a few wks when he plays again. :) keep the ideas coming :)

My goodness its been ages since i've been on here and needed to ask a question (which could be good or bad) but CB has always been a beacon of hope for me. I run sound for a church and we have a flute player in a back corner (no hope of moving, might change in a few months with a new...

could it be the difference between line level and pre-amped sound? or maybe its a ground hum (60 cycle hum anyone?)

so i read through all of these and i used to run the gl2200 and have worked with the 2400 a little bit, should be about the same config. what i would do is check to make sure the outs on the back are plugged in correctly (should be aux out, not group out, for A&H it should be 1/4" plug) and then...

So uh...over dead post but i wanted closure on it. They upgraded a while back to a Shure system :D looks like they finally got smart.

Ok, I never realized that this would spark such a discussion... Unmanedpilot and I currently have moved onto other venues. However I can get in touch with them back home and relay this. I would agree with Landon that a distrubution system would help greatly though the company has always...

So let me see if I have this right. You don't want to buy new equipment, but you will if you need to. Money is not a issue is this regard. You have a two row configuration for brass players in the first row and orchestra in the second. Somewhere else you have singers/musicians. You want a grand...

I'm kind in a bind for how to reply. In the past 8 months I have worked on three different rigs and am in the process of upgrading the most recent rig. None of the equipment is mine which stinks. I guess I'll give you guys the list of equipment I'm upgrading to. In the rack: Crown XLS-602D...

For Monitors, I am doing in-ear monitor's for a couple reasons, first is to lower any stage noise, second is to cut off the cost of another amp and monitor's, third is asthetics, fourth is that with how I am setting up the in ear system I can do more mix for more ppl. I am monitoring the...

Well usually Phil has amazing ideas but I'm gonna offer my two cents on this. I would find out what the name of the A-T connector is and either their service dept can order it or you can google for a bag or single connector of that type

Googling is a special skill that is acquired. I am not the best at it. So I thought you guys would be able to help me out :P

Overloaded the runs? Dang, I didn't know that was possible. Well In that case....looks like i'm gonna go with a passive 5 way split. Any idea where i can get one?