B
brucek
Latest activityPostingsAbout
-
-
Bbrucek replied to the thread Control/Dimming ION XE Intensity Wheel.There is a face panel test utility located within the settings menus, if that is helpful for testing faders, buttons, etc.
-
BSection 520 sidebar: I've got a new house with a main auditorium of 350 retractable seats, and it has zero utility receptacles around...
-
BAwesome, thank you.
-
Bbrucek replied to the thread Outdoor Venue Animal-Proof Cable Shed.Mud wasps like to fill in screw holes on outdoor speakers. I have a flattened drill bit I use for drilling sand out of the holes.As...
-
Bbrucek replied to the thread Control/Dimming 5-wire cable with 3 pin XLR.Paralleling conductors will increase the capacitance between them (long parallel conductors separated by an insulator). Also remember...
-
Bbrucek replied to the thread Socapex Grounding Ring and P14 Motor Cable.Personally I'm not a fan of strapping all the grounds together in the connectors -For 6 circuit cables, in my opinion, should ALWAYS be...
-
Bbrucek replied to the thread Ever had a concussion?.OK, dusting off an old topic.... There is a discussion going on in a parents group of my daughter's college about (at another school) an...
-
Bbrucek replied to the thread Are Theatrical Relays Really Necessary In LED Based Systems.Point being, a dimmer module ALWAYS is passing through the choke and a SCR, where as a relay is chokeless...and air gaped.
-
Bbrucek replied to the thread Trying to understand electrical distro.It is important to note that removing the racks upon racks of dimmer will allow the power service to be smaller (150A vs 200A vs 400A...
-
Bbrucek replied to the thread CD80 SV SSR Drive Connector Pinout?.Try asking Shaun Johnson @ johnson Systems. He might be able to help
-
Bbrucek replied to the thread Trying to understand electrical distro.100A per leg. 3 x 100 = 300A total available. Dimmers are single phase devices, so 24 x 20a = 480A total needed / 3 phase = 160A...
-
Bbrucek replied to the thread Control/Dimming iSeries E 96 dimmer rack configuration software.The software is indeed DOS based. I have never tried to run it in a virtual box. The issues are going to be with serial access and...
-
Bbrucek replied to the thread Control/Dimming Non-Permanent Shutdown Procedures.My ears have perked up......Vampire!?
-
Bbrucek replied to the thread Skirpan Dimmer-Lamp Project!.Looks like we used a Skantronics Inc (A SKIRPAN company) SKT-TTD A6B/A7B Thyristor Driver. All the paperwork is dated 1985-1986. Looks...
-
Bbrucek replied to the thread DMX A & B on a tour pack, and Why some DMX 3 pin and others 5 pin?.The 3 pin vs 5 pin is a matter of 5pin is the DMX512 standard....and 3 pin is the...
-
-
Loading…
-
Loading…
