-
-
DDagger replied to the thread distro 20 amp edison circuit question.Unfortunately I don't have a pic of the back.Another question : is a socapex for lighting drawing from 3 phases? If yes I will have a...
-
DDagger replied to the thread CS-800 and 3 phase reverse.example on the install CS800 is turned to ABC ( running in the correct phase , correct directonal control) cs800 C5 is disconnected and...
-
DWhat is the reason for a CS-800 to be in reverse at times...
-
DI usually choke a 3ft+ sash cord on the cable pick and tie a shoelace know around beam or anchor point.do you guys have a preferred...
-
Ddistro 300 amps main breaker edison (36) @20 amps L6-30 (3) @ 30amps L21-30 (3) @ 30ampsmy questions are :(1) is each...
-
-
DWhich crew member woud you rather invest time in to show the ropes?One can move quickly but talks alot , comments a lot or the other...
-
DUsually take out cotter pins while still at working height , land truss and hammer out 4 pins.I was wondering if it would be possible...
-
-
DDagger posted the thread Potential of scaffold ladder tipping in this scenario in Scenery, Props, and Rigging.in this setup person x ( w/ harness) is on top of a scaffold ladder (20-25 ft) and would have to reach outside as shown in drawing...
-
-
DDagger posted the thread Loosening bolts before landing truss on ground in Scenery, Props, and Rigging.we always lower truss to working height and strip lights, cables etc. and then land truss on ground before unbolting. I was wondering...
-
-
Loading…
-
Loading…
