Recent content by Damaniac311

Sigh, nevermind....I had the mics plugged into the 1/4" jacks, not the XLR. Apparently the 1/4"'s don't get phantom power, just XLR. I hate being a newbie. :rolleyes:

Hi, I have a hanging mic and floor mic on seperate channels on a mackie 1402-vlz pro mixer. the mixer then goes to an amp, and then to my speakers. The problem is I can't get anything out of either mic. I have a few wireless mics on the board as well and they work fine. I have phantom power...

I have run sound for our middle school the past two years, and their setup is not nearly as complex, nor is their auditorium as large as the high school's. I have run simple meetings and presentations in the high school that would only require a mic or two. This is the first time I'm running a...

I apologize for using incorrect terminology...when I say monitors, I'm refering to a set of large Peavey speakers at the front of the stage facing out to the audience, and a set of smaller TOA's at the rear. From the front of the stage to the back of the aud is about 150-200 ft. I felt the...

Hi all, thanks for the quick responses....let me clarify wiring.... The house speakers are on one amp, and the four monitors are on another. The monitors at the rear are connected to the front monitors as a parallel connection. Both amps are set at 50%. Thanks again

Hi all, I would appreciate any help/advice with this... I am running sound for a school musical for the first time this year. I have all the equipment set up as well as I can. I have the house speakers which are essentially center speakers. I have two monitors set up on the aud floor (on...