Recent content by Dan0010

i don't have any photos but I had a space where we had aux panels all over so we had the ability to connect equipment anywhere but it consisted of fiber (multimode and singlemode), cat 6, sdi, and coax, and a couple xlr for audio tie lines and xlr for intercom. Out of everything we used the...

unless I'm misunderstanding the documentation but the microflex is not wifi but uses their own access points that are more like the receiver instead of it being up in the rack. The access point then gets tied to the shure network interface. It similar to if you look at revolabs newer solutions...

do you really need microphones that have receivers with dante outputs (or you mean wired dante mics)? You would need new mixers or a breakout box that takes the connection. I would focus on digital microphones that can be encrypted or at least run on the newer frequencies that are legal to today...

it all depends on how the led screen is setup. as some led walls you just need to split it up and send different content per controller. but to answer your question is you need a multiviewer or a video processor. you probably won't need the switcher however it all depends on how you're using...

for mics that support them i was using the energizer rechargeable but I always go off the advice that if the event is big then I remove the rechargeable and use regular batteries. I'm paranoid that the rechargeable will die even though it fully charge so events that I know someone won't be happy...

i think you can do all that with propresenter not sure about the dmx but it has a midi module you can purchase (if you use the software on a mac) so you might be able to use it to control the dmx over midi

Since this thread came back up. I just wanted to also say I had the same problem with a dell ultra book that has a similar magnetic closing sensor. I spent two days re imaging a computer for an event (which I got from a fellow tech who manages the computers) I thought they were noting working as...

it was the way the network was setup. each floor has it own subnet and the wireless and wired is separated in it own subnet.at this point i'm setting up equipment on one floor and pulling the audio into a sound board into a control room another floor using the network that already in place...

I'm hoping someone is familiar is DANTE in a large network environment.After reading about DANTE I finally have got my shure ulxd and my soundcraft expression 2 (with dante card) connected to the network but I'm having a little issue.The devices are on different subnets with what I thought I...

i got the expression 2 and it good. first time I used the aux for output to cameras that were brought in to film I had them complaining that their was tone while we were setting up. finally realized that it has a tone generator for the auxes so that was something I missed in the manual. the...

i have a feeling that propresenter can be a cheapo character generator in its own way. you can bring live video into it and do slides and text etc. might take some playing around or someone who knows propresenter but might work, i only started playing around with it so someone else might be able...

i started asking for these floor boxes that are really deep. they are great since they have lots of space to plug a cable in and has a rubber gasket that allows you to pass multiple cables through in a closed state. If you don't have any cables and it closed then it completely flushed as I know...

i only basically used it but the guy who bought this was explaining that you can actually have two outputs for this. from the quick overview i had of this it kinda cool. http://www.enco.com/products/dad-radio-automation-presenter.html

not sure if your looking only for wired but i've been using revolabs. there elite series is nice if you want boundary microphones or gooseneck they got both. http://www.revolabs.com/products/product-line/executive-elite/executive-elite-microphonesalthough i would say find an integrator if you...

i was thinking instead of having a plug they should have used this. i had an engineer who only wanted to use this since it easy to just run cables and just pull them out whenever you wanted. forget plugs and pillows. http://www.stifirestop.com/ez-path/