Let me see if I understand correctly. Lets say I am setting the level for an iPod connected to a stereo input on an analog board. I would have the channel fader all the way down then solo the channel and raise the trim until the meter was showing signal at the 0db mark. I would then set the main...
Thanks for the replies. We are not using any AUX sends on the channels so we don't have to worry about the mute button taking out the pre-fade output. The actors are also not switching mics during the show. As far as setting the level, I bring the fader to the 0db position with the trim all the...
I was wondering what the generally accepted practice is for mixing microphones on an analog board specifically for muting. I occasionally run sound for musicals at a local community theater and when the actors enter and exit the stage I just pot their mics all the way down or back up. When...
I received the cables and the good news is the pins are wired correctly on each end. Pin 2 to pin 2 etc. The bad news is I get about 5 volts from the beltpack on pin 3 grounding to pin 1. So if I understand correctly, I should disconnect the wire to Pin3 on the standard XLR end and it won't be...
I ordered a couple of these to try: 6ft 3-Pin XLR Male to 3-Pin Mini XLR Female Microphone Cable - PI Manufacturing Corp. I'll check for voltage when I get them and rewire the standard XLR end if necessary.
I volunteer at a local community theatre and we have an AKG WMS450 wireless mic system. The show we are working on has the talent singing into microphones on stands. The director does not want cables running across the stage so I am looking into using a standard XLR to Mini XLR cable to plug...
You might be able to do what you want using MIDI. That board should read standard MIDI data to control channels as well as Midi Show Control for cue playback etc.
I volunteer at a local community theatre as the lighting designer and board op. I am working on our next production and am looking into controlling our light board and DMX software simultaneously. Our board is a Leviton Innovator 24/48 and it is used to control all the conventional lights. I...
I recommend the Enttec DMX USB Pro. It is a little out of your price range but I find it to be very reliable. There are many free software programs you can use with it.