FMEng's latest activity
-
FResults post. Bought the Motu M4, hooked up to a laptop on a tech table a few rows into the house. Handheld mic on a stand DSC run...
-
FFMEng reacted to Gage's post in the thread Control/Dimming New (to me) EDI Scrimmer II dimmer packs with
Like.
Replaced the rest of the tantalums and the card is working perfectly now. I've honestly never seen a bad tantalum that didn't explode... -
FFMEng replied to the thread Control/Dimming New (to me) EDI Scrimmer II dimmer packs.You are on the right track. Replace all of the tantalum and electrolytics.
-
FA quick look at b and h photo dot com shows DPA brand “heavy duty” 5.5’ cable with microdot at each end. I have used both Senal and...
-
FFMEng replied to the thread Surge protection question.The clamp voltage of the MOVs are surprisingly high, which is why they survive for years of use. Consider that surge protectors are...
-
FFMEng replied to the thread Surge protection question.Most surge protection is a MOV, which acts as a brute force clamp with a fairly high conduction voltage, along with some circuitry to...
-
FFMEng replied to the thread Surge protection question.It seems like an oversight, especially in a lightning prone area. The only way to protect the control electronics is to clamp over...
-
FFMEng replied to the thread Wireless Mic System Refresh.Pardon me if this is a repeat. At my church, I went with Shure QLX-D. It was a couple of years ago, so EW-D and SLX-D didn't exist...
-
FFMEng replied to the thread iMac/Dante - two interfaces.That's what I've done before, dual network the machine with a USB network adapter. I used the built in network interface for Dante, and...
-
FFMEng reacted to JonCarter's post in the thread Control/Dimming New (to me) EDI Scrimmer II dimmer packs with Like.
Gage, referring to your photo of the input connections to your 12 dimer pack, it appears that it is now set up for 3 phase 4 wire...
-
FFMEng replied to the thread Prolight Eclipse FS zoom model?.The Eclipse FS has been renamed EclProfile FS. Check with the distributor to see if the zooms will be going into the production any...
-
FOops I should have mentioned these particular units include my own gear too. Sorry I didn't mean to be unclear about that. I generally...
-
FInstalled mics for a town council meeting room. Like the way it came out.
-
FFMEng replied to the thread Decent Microdot Wireless Headset Cables.Are these cables getting wound around the belt pack at the end of use? That'll break any cable fairly quickly. Store them straight and...
-
FFMEng replied to the thread NSI DDS 6000 dimmers on w/o signal.I found a copy of the manual with a schematic. DDS 6000 manual After looking that over, I would replace C3, 10 uF on the power board...