Recent content by GXander

  1. G

    Saving a show for ETC Express

    Is there some way to create an Express show file on a computer and save it to a floppy, as you could with an EOS series console? How would you make this work?
  2. G

    Bome's MIDI Translator not recognizing ETC Element as input

    I'll look into getting the right driver. I did use one from Windows Update, so maybe it wasn't correct. If that doesn't work, I will weigh buying a controller (the uno one should be at a nearby store) versus just getting someone to advance the projections or doing it myself. It's for a three...
  3. G

    Bome's MIDI Translator not recognizing ETC Element as input

    Thank you. I checked the MIDI TX, and it is on. MIDI-OX is saying that the computer has no MIDI inputs. Is there a driver for the Element that I will need to install, or is the driver for the USB-MIDI interface sufficient?
  4. G

    Bome's MIDI Translator not recognizing ETC Element as input

    I am trying to send MIDI messages from an ETC Element to a computer running Bome's MIDI Translator v1.61 build 896. I am using a MIDI-USB interface from the game Guitar Hero. My computer is recognizing the Element as "GH MIDI INTERFACE," and Bome's MIDI Translator allows me to use this is an...
  5. G

    video over Cat5

    Thank you all for the advice. The length of the run is going to be 100', since that's the length of the cable we have that's long enough. The projector we're going to be using has a maximum resolution of 1024x768, so limiting the aspect ratio to 4:3 isn't a problem. We actually have not done...
  6. G

    video over Cat5

    I am designing projections for a production this fall that will use rear projection onto the cyc for backgrounds. Ideally, our projection operator will be in the booth with lights and sound, rather than behind the cyc where they can't see what is happening. To make this possible and avoid signal...
Back