Recent content by Jason M Wagner

Sorry for the delayed response. I finally discovered the FSii cannot power our entire 2-wire system. It only outputs 800mA per channel pair. So A/B has 800mA and C/D has 800mA. The PS704 has 1.2A per channel. Seems I was overloading the output of the FSii, which is why the power kept turning...

I've been troubleshooting adding a new FreeSpeak II system into our 2-wire ClearCom partyline system, but having issues. The 10-ohm ground resistor in our 704 power supply keeps popping, so we need to figure that out. Leaving the PS-704 out of the system, I'm setting up the FSii as the power...

I can only imagine this discussion has been had before. Directions to those posts??We have a White Muslin cyc downstage of a RP Screen "bounce". We point our cyc lights at the plastic and bounce the light to the cyc. A few groups have come in and said this is wrong and switch it for their...

Thanks all. Yes, the LD and ME were trying to keep the instruments away from the border. However, they went ahead and hung the instruments straight down and we had no issue.How does one use a side arm as a stiffener?

This show is in for two weeks. Should I be concerned with this side-loading? The bracket seems to be putting some pressure on the inside of the thimble.

I will look into it further tomorrow, but we are in a show right now. We're fairly certain it is not a frequency issue, considering it only creates the burst on the release of the talk button. But, not impossible.Also, it doesn't do it every time. It is intermittent.Our base station...

Hello all,We have a Clearcom WTR-670 base station along with 4 WTR-670 belt packs. All packs are set to "Push to Transmit". One of the packs is creating a burst of static when the talk button is released. We tried switching it to "Push to Talk" but with poor signal where the pack is being...

Thought about this, but didn't want to harm the strength/integrity of the fork.This is about where I'm at. Or new/different wheels. Or just new carts altogether.

So, I decided to replace my pneumatic wheels/tires with some flat-free wheels. However, while a 8"x3" wheel "works", the fork curves in a bit too much at the top and the corner/side of the rubber now rubs making it very difficult to move the carts. Short of buying new wheels/tires again, how...

Yes, @BillConnerFASTC, we have the adjustable trim plates. I may look to those to see if I can "fix" my issues.Thanks, @macsound. We get that all the time. Proud of it!

Here's more pictures. You can see we are trying to make the pipe smile with clamps. Doesn't work.I wish I could say. Can you tell from the pictures??

That is a possibility as well. The piping is just regular Home Depot 3/4" conduit. I've looked into maybe getting something a bit more rigid.Is this why I see some drops with bungee built-in to the hour-glass sides?Yes. This is something I missed when we ordered our new scrim. Humidity...

No, not silly. It's entirely possible. Something I need to check out.

Is there a way to plan for this when ordering new soft goods?

Hard to get good pictures, but I think you can see what I'm talking about.