Recent content by LD/SDintraining

Thanks, guys! This really helps!

Hey all,I'm currently working on a cabling project for my Master Electrician course and we have to spec out all of our equipment. Just wondering what the difference between a gateway and Opto Splitter is and what would you recommend for an all intelligent fixture rig of about 120 fixtures...

Hey there, Does anyone know of any good free or cheap DMX Control Software? I have an ENT TEC USB to DMX light controller and will be using a windows laptop if that helps.

Thank you so much! I googled ninety degree scaff clamp for 1.5 and a lot more places poped up.

Does anyone know anywhere I can get cheeseboroughs in Portland, Oregon?

Okay. Thanks so much!

No I haven't. I thought I'd ask here first and see if anyone has had the same problem and if they have how they solved it.

Correct. It just stops and then we turn it off and then back on and it starts going again most of the time.

So my school has a Sawstop Contractor Saw and whenever we go to rip wood (mostly 3/4" plywood) the saw just stops midway through a cut about 4 cuts in. Sometimes it'll do more and then stop but it mostly stops after a few cuts. When it stops we have to pull the wood out, lift it up, turn it off...

So I made a lighting plot on capture atlas and the scaling on that was confusing to me so I made the grid width 6" and did 1'0" per square hoping to make it half inch scale. How would you print the plot off and keep it half inch scale? Also what is a good paper size to use? I can go as big as 24x36.