Oh oh ...I really don't know the TP spects to proceed for it nor a way to do isolated test ... sorry for that ...but her in the booth there are a lot of experts and genuis that could help ....ihop that they can read this thread
For me I almost test all the points around the suspected blown components area...you can also try a live test with power put Take a Great Care cos the probe usually slip and pomp to each other cosing very nice sound and light effect
When you first powering the unite ...Does it flashes that one strong flash ? or also weak ? Did you tray to swap the bulb it self ? also check the bulb type Jumper on the board ..Also test the 3 Power rectifier diodes ...if not ...and if you don't have analyzer to do comparison between the good...
Tray to check L104 ZS1052AC and see if it working or not ....
Also you are saying that ((The lamp strobed right for about 1 min in stand alone mode (1/sec full power), then no more light output.)) ,,this mean that there was still a bad componnent in the first trail ,,,and after the test you...
UPDATE ..
After i find it hard to find the -10V DMX piece for my STRAND ,,, i thought that i must analyze the original Strand LD90 processor output signal ... and i did some testes .. and i found the following :
the LD90 processor piece output 0-1.5V dc output and its fed directly to the LD90...
Good day ,
I Have an old LD90 dimmer rack with its processor board ..... and i need to separate 2 racks in another place and offcorse i have only one processor board that converts digital DMX to analog ... Is there any sort of modification that i can make it run from a 0-10V Demux converter...
You are dam right ,,, i am facing a problem now with re-positioning the tilt encoder indexing sensor ,,,As for the BTW hint ,,its none of my business as i am not the owner ,,i am the repair guy .....hhhhhaaaaa