Recent content by machaelaburt

  1. M

    Issue with Mains

    Thanks! Probably should have led with that: https://www.fullcompass.com/common/files/2917-Sx500SpecSheet.pdf
  2. M

    Issue with Mains

    Hi friends, Thanks for all the troubleshooting tips- Here's where we're at: I've run my phone into the amp via bluetooth and run a separate, passive speaker through the amp with the same results- quiet, distorted, fuzzy sound. I don' t have a second amp currently to diagnose speakers, but from...
  3. M

    Issue with Mains

    Awesome, thanks for this. We don't get a thump at all, we've been pretty consistent with proper power on and off protocols. General consensus says amplifier, I've got a small mixer and other speakers we will start doing some testing with this week!
  4. M

    Issue with Mains

    Yes! Old fangled for sure. The building was built circa 1984 and I believe they are original to that build (I've only been here for five years and this is the first time we've had issues). But, I am fairly certain they are passive. I've rerouted with some less-powerful but definitely okay to get...
  5. M

    Issue with Mains

    Hi Dave, Thanks for the quick response. The amp is a Pyle PTA 1000, I'm getting consistent signal readings from it and from the board. The speakers, I have no idea what model they are, but they have little "EV" insignia on the bottom. I don't have a crossover or processor currently installed...
  6. M

    Issue with Mains

    Hello, I have an older venue with two speakers hung at the proscenium arch. I have a input box on the floor backstage by the speaker lines that is connected via snake to the booth at the back of the auditorium and up to the sound booth which is on the floor above. We've recently purchased a new...