Recent content by MDB

  1. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    SOLVED:grin::!: THANKS TO ALL FOR YOUR HELP. AFTER TRYING ALL OF YOUR SUGGESTIONS, I noticed that the internal light on the WIDGET was variably blinking....as such I tried a new POWER CORD to the WIDGET....and was rewarded with rapid success. I really appreciate all the assistance and...
  2. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    :lol::lol: Good Morning and Thanks to all who gave input overnight. 1) To answer one question, yes I am patching using the fixture profile 2) I did in fact add the 4 VL 2500 from the menu and then patch as expressed. 3) I did not know about the widget assignment menu. So I will try that...
  3. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    Again, My Thanks. Well, I am going to call it quits for the evening. Tomorrow I will check my DMX wiring again...perhaps readdress the instruments....and if none of this works I will call VL and Highend on Monday. If anyone has any other ideas please feel free to leave them here, I will...
  4. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    Thanks -- The DMX cable is plugged into the 1st Universe, and the board is recognizing the Device. My 1st VL is addressed at 23. so i patched 1 @ 23. Yes, I am pretty sure I have grabbed the fixture correctly. Just not getting ANY response from the console....Do you need a termination...
  5. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    Thanks for trying to help. I wasn't aware that the VL 2500's had a DMX OK led. I will check that. The widget is the one that allows for plugging in four different DMX universes. I have plugged my rig into the 1st DMX universe. Also, I am assuming my "patch" was done correctly -- taking the...
  6. M

    Control/Dimming PLEASE HELP...Hog3PC/VL2500S

    Good Afternoon! I am currently using the HOG 3 PC for a show with 4 VL 2500 Spots, and have run into trouble.HELP ME PLEASE.SO the units are correctly hung, powered, and DMX is correctly wired. The console is also set up correctly and detecting the DMX universe. I've noted down the DMX...
  7. M

    Greetings, Hello, and Thanks in Advance!

    :lol: Good afternoon to all and thanks for taking the time to read this. I am a formally trained lighting designer who has been very lucky to have used some pretty hi-end equipment over the last years! This having been said, I haven't acted as an ME or programmer in a LONG TIME. I am...
Back