Recent content by michaelpastushkov

Switching Master / Slave finally made affect. With mixer being Master the clicks and strange sounds are gone, and so is the message about clock errors on the mixer. HOWEVER, new problem arrived: often (every 3-5 minutes) the audio from mixer I/O is getting to the computer (Logic) with 3-4 second...

Using Graphic Patchbay as SW, and Firewire as connection. I tried switching Master / Slave on both side, so they match. No visible difference.

It's O1V 96, Firmware 2.30

It's MY16-mLAN. I tried mapping only first few channels (2 in 2 out) with the same results. The mixer is 16 channel device @ 96, I believe, and 2 FX versus 4 at lower frequencies, which is plenty for me. How do I tell that to mLAN - jumpers maybe?

Thanks! Buying software feels better (less redundancy). Any suggestions what can be a SW clock? I have Logic and Yamaha Patchbay. Well, a bunch of libraries too,.

I was hoping to get it working w/o additional HW, having high-end computer (Mac) and high-end mixer. It's not a question of money. Redundancy feels bad :) Anybody has this setup working at all?

How and where would it come from? I am using Graphic Patchbay and the mixer itself with mLAN in it, there's nothing else (well, there's Logic on the computer side).

Guys, I'be been using O1V and mLAN16 for a while with 48K clock, everything is working OK (connection to Logic, 16 channels in and out). But when I try to switch to 96K clock, I clearly hear clicks in output - I suspect something is wrong with word clock. Has anybody experienced this? Any...