Recent content by nishrigo

I have been using the ENTTEC DMX-USB Pro with Chamsys MagicQ on OS X Yosemite very successfully. Recently my HDD in the mac died, and the replacement HDD came with El Capitan. Now the problem I am facing is that Chamsys will no longer talk to the ENTTEC DMX-USB device, and I cannot disable the...

Hi, I was wondering if the ENTTEC DMX-USB Pro can be configured to output using Artnet. If yes, I would like some pointer on how it can be done.I recently recently read that the dot2 on PC version will output signal using a third party hardware using the Artnet protocol. I have been using...

Hi, I would like to know if any Avolites console - especially the Pearl 2010 or the Pearl Expert - can import and run ASCII show files properly. I have a show coming in from Germany, and I was asked if the console I have can import a file in ASCII fromat, that has been programmed on some other...

I modified a show programmed for grandMA1 on PC to the MagicQ. The show has a master cue stack (PB1 on page 1), and 11 different chase patterns called by different cues in the cue stack. I managed to do this using the macro commands and release a chase once its function was done.The problem I...

I work with a lighting equipment rental company. We currently have touring dimmer racks - one 24 dimmer rack and two 12 dimmer racks, 4000W each. These dimmers are about 10 years or so old and are obviously analog dimmers. We have installed a digital to analog decoder in each dimmer rack, so...

So then, as I had said, the LanBox is configured for ArtNet, and it is shown on Chamsys Magic Q in Setup - View System - ArtNet nodes.But then it stays at that. I have not been able to get the dimmers to respond to the commands sent by Magic Q, and needless to say, I am getting slightly...

Hi,I am trying to figure out whether it is possible to control a Show using the Chamsys Magic Q (PC/MAC version) with a LanBox LCX running a 2.11 firmware.I have been able to configure the LanBox to use the ArtNet protocol, and I am wondering if it would be possible for Magic Q to output the...

Hi, I have a LanBox-LCX which I have configured to work with the ArtNet protocol.I am now trying to get the LanBox to respond to the grandMA1onPC software. The hardware is recognised by the grandMA1onPC software. :grin:But the problem I am facing is that the lights do not respond to the...