NJLX's latest activity
-
NNJLX replied to the thread Chauvet IP 3-Pin Adapters?.I would say that these Chauvet IP DMX to Normal DMX adapters fall under things that should come automatically with a specific item...
-
N100% Agree in the general sense, but In this case, if the rental shop didn't assume I needed a real way to connect data to a BS...
-
NNJLX replied to the thread I-Cue, PATCHING PAN AND TILT.Port 2 is where the DMX cable is plugged in on the back of the express - there's port 1(usually where the cable to the dimmers is...
-
NNJLX replied to the thread I-Cue, PATCHING PAN AND TILT.The other thing to check on the express(if all 3 I-Cues remain not working after the steps listed above) is that port 2 on the express...
-
NNJLX replied to the thread Open 4/12, dmx decoder/LED tape works from board not stage..To clarify on RDM - I don't expect the decoder to have any RDM functions, but one of the troubleshooting steps we usually recommend is...
-
NNJLX replied to the thread Open 4/12, dmx decoder/LED tape works from board not stage..#1 - Your link to the decoder is the same as the link to the LED tape.#2 - Are your decoders(generic RGBW fixtures) patched in the...
-
NNJLX replied to the thread Best practices as house when hosting touring production's lighting network.I'd also like to note that the Cisco switches in ETC installed projects can be configured to block/allow any sACN universes, either...
-
NNJLX replied to the thread Focusing fixtures for an even overhead wash.Remember that beam angles touching at the floor means gaps at head height - Traditionally, you'd plot the beam pools touching at 5' or...
-
NNJLX replied to the thread Recommendations for tool lanyards?.I'm firmly in the squids camp(manufacturer ergodyne - @egilson1 linked above) - I have a couple of the 3100 series - which start at a...
-
NNJLX replied to the thread Color matching between Colorsource and lustr.note that this only works on fixtures that take the RGB value and do the math for extra emitters. Lights that only have RGB emitters, or...
-
NNJLX replied to the thread Color matching between Colorsource and lustr.If both fixtures are in RGB mode, they should match reasonably well. (RGB on these is a calibrated mode, rather than direct control of...
-
NNJLX replied to the thread Design Google sheet template instead of Lightwright?.If your plot is small, the demo version of Lightwright works for up to 75 lights - just download the software from Lightwright.com and...
-
NHonestly that one as far as chain on the thimble goes... is fine. I hate bolt termination of chain like that though.
-
NNJLX replied to the thread Batten rigging configuration..I would recommend replacing the trim chain with a truss pick: https://www.thelightsource.com/products/12-mega-truss-pick-34The Light...
-
NNJLX replied to the thread Pls Help! ETC Dimmer Rack going out!.Note: If the problem follows the dimmer module, it's a bad dimmer module. If the problem stays with the slot, it's a problem with the...
