Recent content by Stagemanager01

So- is it possible it just needs about 20 minutes to become stable?? Has anyone experienced that? Once again, yesterday, I started up everything. It was solid green for about 3 min, then started blinking, then after about 15min, the lights were solid and stable for the rest of the time I was...

Ion Classic ver 2.9 Net2 enabled Edmx enabled (priority 10) Used NCE for configuration It works when initially booted. Then after about 5 min it starts blinking indicating Edmx not outputting. The other day- I got busy doing other things, went back and checked on it after 30 min or so, and it...

Ok- I’m a newbie to adding nodes.I’m using a Etcnet2 Node to get me universes 3-5. I configured the node in the software for the appropriate port outputs for the universes and it sustains an appropriate IP address. When everything first boots up, it works fine, lights and all, but then after...

Hello- I have created a 11ch fixture profile for the Rockville Stage Matrix 36 Fixture with no problems. I also created the 108ch profile so I have the capability of choosing to control each bulb, but it is not behaving correctly, and I am trying to figure out what I might have done wrong...

Ok- I turned the board off and back on. Seems to be behaving. But what in the world. It impacted 10 cues in a row. How does this happen?

Also-if I hit the back button- it behaves correctly

I have tried the Channels Effect at and enter, then updating the cues to take the effect out of the Cue, but it’s not working. What is weird there are no effects listed on the cue list, but the channel table show it running it. This is happening with a few of my cues. Help!!!

I am a bit ignorant when it comes to more than 2 universes, as I have never had to worry about it.But now I want to be ready for it, in case I should need it. I know expensive gateways and nodes will get me there, but I am wondering if the Chauvet DMX-AN2 will work to get me a couple of...

This is a dumb question, I know. I had built a magic sheet on my Ion years ago of a light plot, and I don’t remember having an issue.Can you change the channel that the Eos automatically assigns to the fixture? Or do you have to go in order? I have tried various ways of changing my first...

I picked up a ETC Ion Classic. Everything seems to be working, but 2 submasters (18 & 22), so they aren't even in the same sub groupings. I know probably calling ETC is my best bet, and I will on Monday, but I am posting here to see if anyone had this issue and/or solutions before I call on...

Here is the Unison panel

First, a short back story to my question: last year, we had a power outage during a rehearsal, and I guess when that happens, our ETC Unison system (that controls lobby, house, work lights) stores all the lights and the levels they are on in a preset in the Unison system on the stage lights...

I don’t have a port 3. Port 1 is working.

I have a dmx splitter that shows the signal. Picture shows the about display.

For the current show I had to just go with universe 1/port 1 since I had enough channels-so my patching isn’t going to show anything right now. When I’m plugged into universe 1, I get signal showing I’m getting DMX data. When I plug into universe 2, signal goes away.The output port 2 is set...