There are a few ways to do it. They come out of the box setup to automatically turn on when they see a DMX signal. You can through ETC Concert software change them to RDM mode or DMX Mode. In DMX mode when they see a a level above 50% on the specified Address (Default 512) they will turn on and...
Hello All,I have a Clearcom HME wireless system connected into my wired system. Every so often when the wireless system stops transmitting from the belt packs there will be a high pitch tone at low volume into the wired system. Has anyone experienced this before?
Alright sounds simple enough. I had most of it right in my first attempt. I guess I get to break out the soldering iron next week. Let's not be too harsh on us Canadians.
These are 12 circuit dimmers that use a 15 pin cinch jones. Common on the DB-25 is 13 according to the manual for the converter. I have attached the manual for the converter. Does this mean I just connect pins one through 12 one for one on the jones connector with 13 as ground and on the second...
Hello Everyone,I have a couple LDS analog Dimmers that I am trying to get going. I have bought the DMX to analog converter. I am trying to figure out the wiring for the d-sub 25 pin connector to the Cinch Jones connectors.
I didn't realize it but I must have another device with the same address and it was interfering with it. I re addressed the Hazer and it is working just great now.
It was working fine during programming and manually bringing up the channel on the board but playing back the cue stack it doesn't seem to want to fire.