Recent content by Tim L

Success!!! Tip of the hat to you, JD... Refresh rate did the trick. Lower refresh rate = faster automatic program, and also slightly more latency, but I'll take it!

The Enttec unit is set to "Max" for refresh rate, and I have the option to change to a number from 0-40 instead. I don't see a way on Luminair or Enttec to reduce the number of channels being transmitted, but Luminair does have a "Node" parameter that is currently set to "Broadcast", and can be...

I'll try fooling with the software... Can't ditch the wireless, because I just went totally wireless with the audio, and I no longer have a FOH position to set up a light controller.

I suspected the same thing, but found out the setting you referred to only applies to when you're operating the fixture manually. Has no impact when using DMX. In fact, I switched back and forth between controllers several times to make sure the setting hadn't been bumped somehow.

I have a pair of Chauvet 4-Bar Tri fixtures that I've been using as stage lights for about 3 years. Been using an Obey-10 to control them, typically just using channel 1 fader to call up automatic programs, which has served my purposes very well. I just bought an Enttec ODE and Luminair software...