Recent content by Txreilly

Hello,I am trying to write simultaneous running cues on an ETC Ion board and not getting anywhere. I tried to write a cue with just the cyc channels and have it run during the scene. Then I tried to write cues and select specific channels that did not include the cyc channels before...

Can anyone tell me if the iRFR-BTS can display the current patch. [ETC Ion board] When I select <PATCH> on my iPad it appears that I can patch from the device. I am trying to trouble shoot and would like to see the existing patch. even it its one channel/address at a time. Not sure if I need...

I did not try the "tab 99 diagnostics." I missed this. I will look into it. Thank you!

Okay, FIRST, thank you for all your help. I was able to ping from the iPad and from the console. Two IT guys came by today and their only thought was that our institution may be putting blocks on the network. We were able to see the IP address and, like I said, on the console screen, the...

Once upon a time I was able to control the ETC Ion remotely from an app on my iPad. Now, the app indicates that it is disconnected and to select the alien [cube] to connect, but when I check this I have a "connected" indicator including green light and gray internet signal [should the signal...

Not sure how these threads work so this is my second reply with the same answer. After all this, I did go with the 15' 7" drops. We have Used both drops several times. Hanging and leveling has been no problem. We have a rolling scaffold which makes a big difference. Thank you ALL for your...

MAY 2014. That's when I was researching. I made a decision to order the drops short. 15' 7" for a 16' grid. I have to eye it when I hang it by having someone on the deck while I tie it to the batten. We have a rolling scaffold so it's not too arduous a task. All has worked out well. The...

I've recorded looks in my faders to assist in designing a show, i.e. front warms in one fader, front cools in the next and so on. I have several different types of moving/color changing lights: Wybron scrollers, I-Cues, Clay Paky, LEDs. When I try to use any of the faders while in a...

I finally did this and it is great! Thank you all. I also (at the instrument) toggled Lon (lamp on mode) to "no" and LDmx to "on." via the manual under "Lamp on mode" and "Enable lamp control DMX channel/Used for enabling lamp remote control channel." In my Alpha Spot HPE 300 manual page 16.

Thanks much! Will try that.

I have tried to load cues only from the offline editor to the Ion board and I lose my patch. What's up?I go to load the show, deselect all and then select cues.Do I need to "import" the cues ?Thanks,Anthony

Thanks much!

Great! I typed the channels that are in the effect and then typed <effect> 3 <enter>. It stopped the effect. How can I just take the effect out of the cue? There's an "EXT LINKS" column and "E 3" is in the column. I looked in the manual and it told me how to stop the effect, but not how to...

Hello,Can anyone tell me if/how I can turn off the lamp in a Clay Paky HPE 300 S? The instrument is not accessible from the deck and the breaker that controls it also controls other instruments that I don't want to shut down.Thanks much,Anthony.

Hi all,I successfully created a camera flash effect and successfully recorded the effect to a fader AND in a cue. I recorded the effect with a cycle time of 2.39 seconds and a duration of 1-cycle. When I execute the effect in the fader using one of the bump buttons the effect runs for 1...