Recent content by Will Abele

Are you planning to pull the snake out of the conduit once it is run, or will it be permanently installed? If it is a permanent install I would buy the cable unterminated then solder the connectors and add heatshrink myself. Multipin connectors tend to be very expensive.

I have had a similar problem with one of the first generation receivers. I had to send it back to Sennheiser to be repaired. It took over a month and a half for them to replace the part and cost approximately $200. They charged around $20 just for shipping. I have found Sennheiser's repair...

Cut off the connectors and buy these to solder on as replacements. http://www.redco.com/shopexd.asp?id=309 Use heat shrink for the strain relief. We use Sennheiser mics and had this problem until we started wrapping the cable under the bodypack one time and taping it before giving to the...