Recent content by ZB370

  1. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    I believe the electronic patch module was something you could add on to the board. Other add ins include an effects board, a remote board, and the Celebrity Plus add-on. I actually called Emlight Design last night and spoke with a gentleman there who was surprised to find out they did have the...
  2. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    Sorry about the confusion with the pictures. That is in fact the celebrity board, the only board connect to the dimmer. I removed it from the shelf to take a better picture of the face of it since the cabinet is locked and I can't find who has the key for it.
  3. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    I have the address set to binary 1. The 1 switch on all else off. I have tried toggling the 10 switch but to no avail. On the front of the dimmer box only the power light is on not channel or data/temp. All three fuses are good and I am trying to just run one dimmer box no daisy chain for right...
  4. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    For the daisy chaining, the only input places on the dimmer packs are a 4 prong and 5 prong female plugs. So I need to use my 4 prong cable to dimmer 1, 5 prong out of dimmer 1 into the 4 prong plug on dimmer 2? Where would I order a 4 prong male to 5 prong male cable? Is it common enough to be...
  5. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    I did notice that the 12 switched are all flipped up. I believe this is the address? Like a binary yes or no?Yes I'm sure they work haha. That was the first thing I checked. I can out each dimmer in seq mode under the test switch and the lights will come on as the sequence through, out of the...
  6. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    derekleffew: Thank you so much for you response. I did read that thread you referenced, and I had some questions about it. I have read some about ECMux and what I read explains what each of the pins in the connector is for. As for the cable, is this a special ECMux cable or just a plain 4 pin...
  7. Z

    Vintage Lighting Electro Controls Celebrity Board - Help needed

    A local middle school is putting on a production of Willy Wonka, and, since one of the directors knows me very well, I have been asked to help them sort out their sound and lighting situation. I have little experience with theater lighting, only the two basic systems, which I can not even recall...
Back