BRoll
Member
Hello all!
New to the forum,but long time lurker.
Been having an issue with a Barco CLM HD8 projector.
Seems that occasionally the #3 lamp fails to strike.
It's running the most current firmware,relatively low hours(300) on it, the lamp module has been checked and re-seated & cables checked.
It does throw an error code of:
<err>: (7340070) Handled ERROR - 1023:Lamp 3 is not ON (10 times) (in SHB[203])
Mode_standby_eco(in SHB[203])
IR_INT done(in SHB[203])
Mode_operational(in SHB[203])
I haven't had the projector's power checked under load yet,waiting on an electrician to do that.
Projector Toolset shows the voltage as follows:
Lamp 1: 83v
Lamp 1 Front: 7.88v
Lamp 1 Back: 16.63v
Lamp 2: 85v
Lamp 2 Front: 7.88v
Lamp 2 Back: 16.63v
Lamp 3: 100v
Lamp 3 Front: 7.88v
Lamp 3 Back: 16.63v
Lamp 4: 107v
Lamp 4 Front: 7.88v
Lamp 4 Back: 16.63v
Has anyone seen/experienced this before or know what any of this means?
Thanks in advance for any advice.
New to the forum,but long time lurker.
Been having an issue with a Barco CLM HD8 projector.
Seems that occasionally the #3 lamp fails to strike.
It's running the most current firmware,relatively low hours(300) on it, the lamp module has been checked and re-seated & cables checked.
It does throw an error code of:
<err>: (7340070) Handled ERROR - 1023:Lamp 3 is not ON (10 times) (in SHB[203])
Mode_standby_eco(in SHB[203])
IR_INT done(in SHB[203])
Mode_operational(in SHB[203])
I haven't had the projector's power checked under load yet,waiting on an electrician to do that.
Projector Toolset shows the voltage as follows:
Lamp 1: 83v
Lamp 1 Front: 7.88v
Lamp 1 Back: 16.63v
Lamp 2: 85v
Lamp 2 Front: 7.88v
Lamp 2 Back: 16.63v
Lamp 3: 100v
Lamp 3 Front: 7.88v
Lamp 3 Back: 16.63v
Lamp 4: 107v
Lamp 4 Front: 7.88v
Lamp 4 Back: 16.63v
Has anyone seen/experienced this before or know what any of this means?
Thanks in advance for any advice.