Crisp image
Well-Known Member
Good Afternoon all,
I have a whole bunch of Chauvet Reve E-3 in a venue that I am working. We have them connected up in 14ch2 mode and the console is an ECT GIO running the latest software (3.1.5 I think)
what we have found is when recorded to a sub and we snap the sub up to full the fixture will fade up over time and not snap up. If we bump it on the bump button it flashes to full in an instant.
The dimming curves are turned off on the fixtures. How can we make these fixtures snap up without using the bump button?
They are only new (I unboxed some a few weeks ago) however they may have been sitting there for some time.
Looking forward to your suggestions.
Regards
Geoff
I have a whole bunch of Chauvet Reve E-3 in a venue that I am working. We have them connected up in 14ch2 mode and the console is an ECT GIO running the latest software (3.1.5 I think)
what we have found is when recorded to a sub and we snap the sub up to full the fixture will fade up over time and not snap up. If we bump it on the bump button it flashes to full in an instant.
The dimming curves are turned off on the fixtures. How can we make these fixtures snap up without using the bump button?
They are only new (I unboxed some a few weeks ago) however they may have been sitting there for some time.
Looking forward to your suggestions.
Regards
Geoff