Kevin Smith
Member
I am trying to add some lights to an existing setup. I have an ETC ColorSourceAV light console (running outdated software, but I'm not updating until after our show in a couple of weeks, don't want to tempt fate), and I want to add some Chauvet SlimPar56 lights. I've plugged the lights into the board, using a 3-5pin adapter, and tried running the light in either 3-channel or 7-channel DMX mode to no avail. I made sure there were no DMX overlaps and set the lights to the starting DMX address where the lights were patched on the board. I have absolutely no control over the lights.
When viewing my DMX universe, I noticed that all of my other lights are running 5 DMX channels, and I didn't know if that makes any difference.
If this is a software issue, I will have to deal with it later, but I figured I would ask here, and see if anyone has any other suggestions.
When viewing my DMX universe, I noticed that all of my other lights are running 5 DMX channels, and I didn't know if that makes any difference.
If this is a software issue, I will have to deal with it later, but I figured I would ask here, and see if anyone has any other suggestions.