Chauvet Strike 4 flashing (not strobing)

Discussion in 'Lighting and Electrics' started by Soundsultan, May 3, 2019.

  1. Soundsultan

    Soundsultan Member

    Messages:
    1
    Likes Received:
    1
    Location:
    North Charleston, SC
    Has anyone in the booth, who has Chauvet's Strike 4 fixtures, experienced them FLASHING when running them to full intensity? It starts around 40% and stops at 75% and works great on either side of those values. It does the same thing when you completely remove DMX and just use the buttons on the back in dimmer mode. Inside that window it flashes. Unit is currently in Florida getting checked out. Thanks for reading!!!!
     
    RonHebbard likes this.
  2. DaveySimps

    DaveySimps CBMod CB Mods Premium Member

    Messages:
    2,842
    Likes Received:
    247
    Occupation:
    Performing Arts Center Manager
    Location:
    Macomb, MI
    I relocated this thread to the Lighting Forum so it is posted in the right spot. Hopefully you get some better traffic here.

    ~Dave
     
  3. Amiers

    Amiers Renting to Corporate One Fixture at a Time.

    Messages:
    3,216
    Likes Received:
    1,311
    Occupation:
    Lighting Floor Tech
    Location:
    Phoenix, Az
    Depends on what mode you had them in.

    If they were in 9 channel mode and you messed with the dimmer speed on channel 9 then yeah it would do some funky dimming. Even with the buttons if that section is at a certain value as well.

    https://www.chauvetprofessional.com/wp-content/uploads/2015/07/Strike_4_DMX_EN_Rev1_WO.pdf

    DMX map.

    https://www.chauvetprofessional.com/wp-content/uploads/2016/05/Strike_4_UM_Rev2_WO.pdf

    Manual if you don’t have one.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice