benintights
Member
Hi, we recently rented 6 ProSpot 250's, and after setting them up and connecting them to power and data, we noticed that they immediately started up in different home positions.
We're not exactly sure how to change these positions, and we have pre-programmed sequences, so it's really not looking good.
I pulled up the manual from off of the Internet and also messed around with the 'menu' on the side of the movers. There were places where you could alter the pan and tilt (and a bunch of other attributes), but every time we exited the 'special' menu, the settings never saved. We contacted the company renting them out to us, and they were confident that the last group to use them did this, but we not aware of how to correct the issue.
Can anyone help? It's very important!
benintights & others
We're not exactly sure how to change these positions, and we have pre-programmed sequences, so it's really not looking good.
I pulled up the manual from off of the Internet and also messed around with the 'menu' on the side of the movers. There were places where you could alter the pan and tilt (and a bunch of other attributes), but every time we exited the 'special' menu, the settings never saved. We contacted the company renting them out to us, and they were confident that the last group to use them did this, but we not aware of how to correct the issue.
Can anyone help? It's very important!
benintights & others