So i am doing a show with some colorblazes and Colorblasts, and a couple moving lights..nothing too fancy.
I've worked with the color kinetics before, on Hog3PC, express, and obsession consoles.
But for this gig i decide to go with the GrandMA.
I set everything up, i address the fixtures. run the cable out to the board, select "standard LED fixture" from the set up.
and then....nothing.
They were on and glowing "dim" but i had no overall control over them.
I took a backup Lepricon 624 (basic 2 scene DMX board) hooked it up, and the lights went out, and sure enough, i had full 3 channel control over the lights.
What am i doing wrong on the MA!>?!?
I've worked with the color kinetics before, on Hog3PC, express, and obsession consoles.
But for this gig i decide to go with the GrandMA.
I set everything up, i address the fixtures. run the cable out to the board, select "standard LED fixture" from the set up.
and then....nothing.
They were on and glowing "dim" but i had no overall control over them.
I took a backup Lepricon 624 (basic 2 scene DMX board) hooked it up, and the lights went out, and sure enough, i had full 3 channel control over the lights.
What am i doing wrong on the MA!>?!?
Last edited: