If the
manual is to be believed:
DMX is enabled by setting
DIP switch 10 to ON and setting the
address using switches 0-9.
The
console expects to control a 4-channel
fixture with the following
profile:
Ch1 - Red 1-255
Ch2 - Green 1-255
Ch3 - Blue 1-255
Ch4 -
Dimmer 0=Off,1-189
dimmer, 190-250 flash, 251-255 full on
Searching the
Fixture Release Notes (
bundled with the offline client), these profiles look like they might be a good starting
point. The tricky part will be setting up Ch4, which requires range programming.
Alkalite Octostrip_4ch
Alkalite Tracpod_84_4ch
American DJ _46HP_LED_4ch
American DJ Pro_Par_56_RGB_4ch
Take any one of them, and if necessary, copy and edit the
intensity channel to map to the range specified in the
manual.
Posting the same question at
ETC's forum with a reference to the exact manufacturer and model name, along with a link to the
manual would likely yield a custom
profile. They are quite responsive about this sort of request, especially when given enough info to make it happen.