Robert F Jarvis
Well-Known Member
Hope some one has a better memory then me here! Our LED Tape 12volt dongles were plugged into a floating dimmer pack to be able to cut power after shut down. But after DMX control was lost the tapes would start flashing. And Control Booth forum noted that these packs have a current leakage issue. I think some one told me about a commercial DMX controlled mains power relay box. I have one those 4 channel open pcb and relays I could build into a box I suppose but a commercial one might save time and be safer. What do some of you do when you remove the DMX signal from LED Tape and other LED equipment? I could around the place and pull a lot of plugs from the wall but!