EDI twilight controller issue

JVTD

Member
Hello, I have a twilight control system in my auditorium and last week something happened to the system and now only the main LCD panel works. The other panels are on but none of the buttons respond when pressed. I suspect it may have been a power outage or brown out that caused the system to reset with errors. Anybody have any suggestions?
 
I would urge you to try Alan Child first, since he was an engineer for EDI. He usually knows the programming for these things off the top of his head.
 
1. Power cycle the whole system. Let it sit off for a good 2 minutes to make sure the memory is cleared.
2. Call Alan - He has been fantastic, several times.

There is software for programming those. Do you have a floppy disk on the dimmer rack? If so you might be able to reload the configuration. If not you will need someone with some (old) IT skills to get it to run and read/write to a floppy. The formatting on those floppies is weird too (720K).
 

Users who are viewing this thread

Back